Sunrise Roof Pros provides professional flat & low-slope sections in Sunrise, FL for residential and commercial properties across west Broward County. Almost every Sunrise house with a tile roof also has a piece of low-slope roof: a Florida room, a rear addition, a screened patio cover. The leak is rarely in the middle of that membrane. It is at the line where the tile field ends and the flat section begins.
That line is a termination detail, and it is the hardest thing on a residential roof to get right. The tile underlayment has to run down onto the low-slope membrane and be lapped so water crosses from one system to the other in the right direction, with the flat material on top of nothing and under nothing it should not be. Reversed there, the joint leaks in the first hard rain.
We build the tie-in as a designed joint. The tile course above stops on a metal transition with a hemmed edge, the base plies come down over it, and the low-slope membrane laps the transition rather than butting it. Then the first tile course is held clear so the joint can dry between storms instead of staying wet under mortar.
On the flat field itself we work in modified bitumen or single-ply depending on what is there and what it ties into. Torch-applied and self-adhered cap sheets both do well over a residential addition; a small TPO or PVC field over cover board makes sense where a mechanical unit sits on it. What matters more than the brand is the perimeter, where wind gets under an edge that was never mechanically terminated.
Slope is the other honest conversation. A dead-flat addition roof built to shed onto a scupper that has since been screened over will hold water no matter what membrane you buy, and tapered insulation to build a real fall is a bigger job than a recover. We will tell you which one your roof needs and price both rather than sell the cheap one twice.
Where the low-slope section is sound, we leave it alone. A five-year-old cap sheet with tight laps does not need replacing because the tile above it is coming off, and rolling it into the reroof scope because it is convenient is not the same as it being necessary. We tie the new tile underlayment into the existing membrane and note the joint in the warranty.
Our licensed and insured team brings the right materials and equipment to every job — two-ply tile underlayment with a mineral-surfaced cap sheet, RAS 118 mortar-set hip and ridge, RAS 120 mechanically fastened tile, tin-capped base sheet fastening on a 12-inch grid, eave riser and anti-ponding strip, two-component polyurethane tile adhesive — and backs the work with a written workmanship warranty. We serve Sunrise and nearby communities including Plantation, Davie, Weston, Tamarac.
What We Handle
Everything our flat & low-slope sections in Sunrise covers
One crew, one point of contact, and the full range of flat & low-slope sections work in Sunrise, FL. If it is on this list we do it in house rather than handing it to a subcontractor:
- flat roof repair
- low-slope roofing
- tile to flat tie-in
- modified bitumen roof
- TPO roofing
- Florida room roof
- screen enclosure roof
- parapet flashing
- porch roof membrane
- low-slope termination detail
- tapered insulation
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Sunrise services.
Materials, equipment and how we do flat & low-slope sections
The difference between flat & low-slope sections that lasts and flat & low-slope sections that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with two-ply tile underlayment with a mineral-surfaced cap sheet, RAS 118 mortar-set hip and ridge, RAS 120 mechanically fastened tile, tin-capped base sheet fastening on a 12-inch grid, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Sunrise job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in west Broward County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do flat & low-slope sections outside Sunrise
Sunrise Roof Pros covers Sunrise and the surrounding communities of west Broward County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Flat & Low-Slope Sections in Plantation, FL — Broward County, population 91,750
- Flat & Low-Slope Sections in Davie, FL — Broward County, population 105,691
- Flat & Low-Slope Sections in Weston, FL — Broward County, population 68,107
- Flat & Low-Slope Sections in Tamarac, FL — Broward County, population 71,897
- Flat & Low-Slope Sections in Lauderhill, FL — Broward County, population 74,482
- Flat & Low-Slope Sections in North Lauderdale, FL — Broward County, population 44,794
Start on the Sunrise Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Sunrise Chooses Sunrise Roof Pros
- ✓We quote from an opened assembly, lifting tile at valleys, penetrations and field corners rather than pricing from a drone photograph.
- ✓Every proposal names the underlayment system, the tile attachment standard and the Miami-Dade Notice of Acceptance numbers we are working to.
- ✓Deck repair is a written unit rate with an allowance, so soft plywood found after tear-off is not a surprise change order.
- ✓We will tell you when a repair beats a replacement, and we will decline tile sealing packages and coatings sold as underlayment substitutes.
The standards behind flat & low-slope sections
Quality here is not a matter of opinion — it is written down. The flat & low-slope sections work we do in Sunrise follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every flat & low-slope sections project in Sunrise gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free flat & low-slope sections free estimate in Sunrise, or request a quote and we'll get right back to you.