Sunrise Roof Pros provides professional fascia & soffit in Sunrise, FL for residential and commercial properties across west Broward County. The eave is where a tile roof confesses. Long before a ceiling stains, water running behind the first course finds the fascia board, the paint blisters, the nails weep rust, and a soffit panel sags. By then the underlayment at the eave has been wet for years.
So we treat fascia rot as a roofing symptom rather than a carpentry job. Replacing the board without finding out why it got wet buys you a matching failure in three years. The usual causes are a missing gutter apron, an eave riser strip that was never installed so the bottom course holds water, or underlayment cut short of the drip edge.
Repair goes back to sound wood. Rotten sub-fascia comes off to the nearest solid rafter tail, tails get sistered where they are soft, and the new board goes on before any metal or trim. Wrapping a rotten board in aluminum is common, fast, and the reason so many Broward eaves are hollow behind a bright white face. A screwdriver pushed into the wood at three points tells you which you have.
For the finish we favour cellular PVC trim or a properly broken aluminum wrap over a sound wood board, with the fastener line above the gutter so nothing is holding water. Both survive this climate. What does not survive is a wood fascia with cut ends left unprimed, because the end grain drinks and the failure starts where nobody looks. We prime cuts on site, which costs minutes and buys years.
Soffit is the intake half of your attic ventilation and gets specified that way. Vented aluminum or PVC panels with a stated net free area, installed in a channel that is actually open to the attic and not blocked by insulation or by a solid nailer, are what makes a ridge vent work. Solid panels on a house with ridge exhaust is a common and quiet mistake.
Blow-outs deserve their own note. Soffit panels that let go in a storm let wind pressure into the attic and lift the roof from inside, which is why a loose panel is worth fixing before hurricane season rather than after. It is a cheap job on a still day and an expensive one as part of a claim. We check panel fastening on every eave we open.
Our licensed and insured team brings the right materials and equipment to every job — two-ply tile underlayment with a mineral-surfaced cap sheet, RAS 118 mortar-set hip and ridge, RAS 120 mechanically fastened tile, tin-capped base sheet fastening on a 12-inch grid, eave riser and anti-ponding strip, two-component polyurethane tile adhesive — and backs the work with a written workmanship warranty. We serve Sunrise and nearby communities including Plantation, Davie, Weston, Tamarac.
What We Handle
Everything our fascia & soffit in Sunrise covers
One crew, one point of contact, and the full range of fascia & soffit work in Sunrise, FL. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia and soffit
- fascia repair
- soffit repair
- rotten fascia board
- vented aluminum soffit
- eave riser strip
- sub-fascia replacement
- soffit blow-out
- PVC fascia trim
- eave repair
- soffit intake vent
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Sunrise services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with two-ply tile underlayment with a mineral-surfaced cap sheet, RAS 118 mortar-set hip and ridge, RAS 120 mechanically fastened tile, tin-capped base sheet fastening on a 12-inch grid, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Sunrise job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in west Broward County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Sunrise
Sunrise Roof Pros covers Sunrise and the surrounding communities of west Broward County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Plantation, FL — Broward County, population 91,750
- Fascia & Soffit in Davie, FL — Broward County, population 105,691
- Fascia & Soffit in Weston, FL — Broward County, population 68,107
- Fascia & Soffit in Tamarac, FL — Broward County, population 71,897
- Fascia & Soffit in Lauderhill, FL — Broward County, population 74,482
- Fascia & Soffit in North Lauderdale, FL — Broward County, population 44,794
Start on the Sunrise Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Sunrise Chooses Sunrise Roof Pros
- ✓We quote from an opened assembly, lifting tile at valleys, penetrations and field corners rather than pricing from a drone photograph.
- ✓Every proposal names the underlayment system, the tile attachment standard and the Miami-Dade Notice of Acceptance numbers we are working to.
- ✓Deck repair is a written unit rate with an allowance, so soft plywood found after tear-off is not a surprise change order.
- ✓We will tell you when a repair beats a replacement, and we will decline tile sealing packages and coatings sold as underlayment substitutes.
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Sunrise follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Sunrise gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Sunrise, or request a quote and we'll get right back to you.