Sunrise Roof Pros provides professional chimney & wall flashing in Sunrise, FL for residential and commercial properties across west Broward County. Real masonry chimneys are uncommon on Sunrise houses, so most reported chimney leaks here are wall terminations: a stucco wall landing in a tile field, a chase for a flue, or the headwall where an addition meets the main roof. The physics is the same and so is the fix.
Every one of those is a place where the underlayment has to turn up a vertical surface and be held there by metal, not by sealant. Step flashing woven into the plies course by course, counterflashing let into a reglet cut in the stucco or into a mortar joint, and the tile set clear so water is thrown out rather than dammed. Caulk across the joint is a repair with an expiry date.
Kickout flashing is the piece most often missing. Where a roof edge meets a wall that continues past it, the water has to be diverted out into the gutter, and without a kickout it runs behind the wall cladding instead. That is the leak that shows up as a stain on an interior wall a meter below the ceiling and gets blamed on plumbing for two years.
On a wide chimney or chase, uphill drainage needs a cricket. A saddle framed and flashed behind the masonry splits the water to both sides instead of letting it pile against the up-slope face, and on a tile roof it also keeps debris from building a dam there. Without one, the up-slope mortar joint is the lowest point in a puddle.
Stucco terminations need a cut, not a smear. We saw a reglet, set the counterflashing into it, and seal the reglet rather than the field, because sealant on a stucco face is holding on to a surface that will spall. Where a previous crew has already covered a joint in mastic, we take it back to substrate before flashing, which is why these repairs cost more than another bead.
We will tell you when the chimney is not the problem. Plenty of stains near a chase turn out to be a pipe boot two feet uphill or a valley that is backing up, and a water test with a hose, working from low to high, sorts it out in half an hour. That test is cheap. Reflashing a chase that was watertight is not.
Our licensed and insured team brings the right materials and equipment to every job — two-ply tile underlayment with a mineral-surfaced cap sheet, RAS 118 mortar-set hip and ridge, RAS 120 mechanically fastened tile, tin-capped base sheet fastening on a 12-inch grid, eave riser and anti-ponding strip, two-component polyurethane tile adhesive — and backs the work with a written workmanship warranty. We serve Sunrise and nearby communities including Plantation, Davie, Weston, Tamarac.
What We Handle
Everything our chimney & wall flashing in Sunrise covers
One crew, one point of contact, and the full range of chimney & wall flashing work in Sunrise, FL. If it is on this list we do it in house rather than handing it to a subcontractor:
- chimney flashing
- wall flashing repair
- step and counterflashing
- chimney cricket
- headwall flashing
- stucco wall termination
- chase cover repair
- kickout flashing
- reglet counterflashing
- chimney leak repair
- masonry joint flashing
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Sunrise services.
Materials, equipment and how we do chimney & wall flashing
The difference between chimney & wall flashing that lasts and chimney & wall flashing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with two-ply tile underlayment with a mineral-surfaced cap sheet, RAS 118 mortar-set hip and ridge, RAS 120 mechanically fastened tile, tin-capped base sheet fastening on a 12-inch grid, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Sunrise job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in west Broward County means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do chimney & wall flashing outside Sunrise
Sunrise Roof Pros covers Sunrise and the surrounding communities of west Broward County. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Chimney & Wall Flashing in Plantation, FL — Broward County, population 91,750
- Chimney & Wall Flashing in Davie, FL — Broward County, population 105,691
- Chimney & Wall Flashing in Weston, FL — Broward County, population 68,107
- Chimney & Wall Flashing in Tamarac, FL — Broward County, population 71,897
- Chimney & Wall Flashing in Lauderhill, FL — Broward County, population 74,482
- Chimney & Wall Flashing in North Lauderdale, FL — Broward County, population 44,794
Start on the Sunrise Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Sunrise Chooses Sunrise Roof Pros
- ✓We quote from an opened assembly, lifting tile at valleys, penetrations and field corners rather than pricing from a drone photograph.
- ✓Every proposal names the underlayment system, the tile attachment standard and the Miami-Dade Notice of Acceptance numbers we are working to.
- ✓Deck repair is a written unit rate with an allowance, so soft plywood found after tear-off is not a surprise change order.
- ✓We will tell you when a repair beats a replacement, and we will decline tile sealing packages and coatings sold as underlayment substitutes.
The standards behind chimney & wall flashing
Quality here is not a matter of opinion — it is written down. The chimney & wall flashing work we do in Sunrise follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every chimney & wall flashing project in Sunrise gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free chimney & wall flashing free estimate in Sunrise, or request a quote and we'll get right back to you.